Subaru H6 Magnaflow bolt on mainfold
Posted: Thu Jun 13, 2019 8:22 am
Recently got myself a '07 Outback with H6 3.0 5EAT. I will be looking into a bit of fine tuning it in near future but first it needs some care as it has over 300k km on the clock.
There is some repairs done on the exhaust from headers to all the way back and looking to start replacing that mess, starting from the engine side.
Has anyone some experience with Magnaflow bolt-on kits?
https://www.magnaflow.com/products/5581 ... -converter
https://www.magnaflow.com/products/5581 ... -converter
Im wondering if there are any gains over the Subaru Stock units. Sure some Raptor headers would be nice, im also looking into this with custom setup as i will not be able to reuse the current stock mess i have under there.
Thanks for any piece of advice.
There is some repairs done on the exhaust from headers to all the way back and looking to start replacing that mess, starting from the engine side.
Has anyone some experience with Magnaflow bolt-on kits?
https://www.magnaflow.com/products/5581 ... -converter
https://www.magnaflow.com/products/5581 ... -converter
Im wondering if there are any gains over the Subaru Stock units. Sure some Raptor headers would be nice, im also looking into this with custom setup as i will not be able to reuse the current stock mess i have under there.
Thanks for any piece of advice.